shower

Hi, Had a bathroom renovation done, new shower & bath. Unfortunately the new shower with narrow pipes & joints, splitter tap for fixed head & removeable etc. does not have the same flow rate as the old, actually now fixed head unusable, dripples & removable barely better but can be used. Use to...

I have a ten year old Provost Riser Rail System with Integrated Shower Mixer and Thermostatic ABS (Ultra) (pic attached) which is now beginning to leak a little around the on/off tap on the left hand side. It might just be a washer that needs replacing, but there is no obvious way to gain access...

Hello, I fitted a shower last year that has two outputs, one standard shower, and another rainfall head in the ceiling. When I setup the valve control, I made the median temperature an acceptable warmth so that the dial was directly between hot and cold and in the center of the valves travel...

Hi, I am thinking of using either white or clear CT1 to re-seal a leaking shower tray. I know it is expensive so would it be just as good to use a good grade silicone sealant. I obviously need something that will last and is waterproof. Any other suggestions are welcome many thanks

Is it possible to swap a concealed shower without removing tiles if can get a similar model.

Hi, just a quick question about the standard way you connect 40mm waste pipe to the outlet of this waste I have. The waste outlet is too big compared to the tube to be solvent welded (it's more like 43mm internal diam) and there are no threads to allow a compression fitting, I'm confused. Pics...

Hi, best way to go about fitting these? The length of thread means the back plate elbow is deep in the wall for the square shroud to fit flush with the tile. Is it best so sit the back plate elbow forward and trim down the Brass thread ? Regards

My aqualisa shower drips when turned off. Reluctant to change the whole cartridge (mechanical Aqualisa Thermostatic Cartridge Grey). I heard that it could be because of worn out washer and one could possibly change, with some difficulty because of restricted access the "O" washer at the back of...

Dear Professionals, could you please advise. I have standard mixer tap in my bath (its about 15 years old, i recently bought the house). The water comes out from tap itself in massive amounts, bath can be filled in 3min, same if i unscrew shower hose - the water will shoot up very high, however...

Hi, I have a leak on the hot water inlet of my concealed Aqualisa Gainsborough shower. I have stripped it back and with the hot water feed on I can see the drip appear at the bottom of the plastic screw fitting. I want to ensure that when I re-tile it, I won't have the same problem in the...

Hi, looking to do two projects: PROJECT (A): Want to bring garage WC to below the stairs pantry PROJECT (B): Then maybe turn the garage WC area into a shower room Pic of the PROJECT (A) basic move: Pic of the garage WC: Pic of the pantry area: Garage WC and Pantry on either side of...

Hi For the past 2 months my shower has been draining slowly and bubbling like there an air block. I've put 3 loads of drain cleaner down, but still not draining properly. Any advice would be very greatfully received. Thanks Jim

Hello, Im looking for help in tracking down a replacement part for an Aqualisa Energy 10.5 Kw Shower. The bit that has started leaking is the top facing mains entry point- Im using the bottom entry point. Ive attached a few pics of the part in question. It has the grey sleeve in the centre of...

Hi All I need some advice as to a replacement power shower and there are a few problems I have posted a photo showing the old unit ( a ShowerForce 2000 ); it has supply pipes which run down from the roof and into the left side of the unit as shown The big problem is that the hot and cold are...

Fixing the upright of a shower enclosure Is there anyway of getting a good fixing, where the upright of the shower enclosure meets the continuous edge of large vertical porcelain tiles? I'm concerned about the possible cracking of tiles with holes drilled so near to the edge, and also the...

I bought this shower mixer unit from Victoria Plumb some years ago, & one of the handles has come off & I cannot manage to re-fit it to the mixer unit arm (see photos). It was in place for a long time but somehow came off recently but no matter how much pressure I apply to try to push it back...

I'm about to install a P shaped shower bath into a small bathroom. However I've noticed that with the bath in place it's not possible to reach under the bath to the pre drilled tap holes. Because of the circular shape there's also no line of sight to these either making it very hard or...

Electrical shower problems I have installed a new shower and when the dial is turned to economy the light on the shower comes on but no water flows through, have checked water pipes and the are not blocked, when the dial is turned to hot or cold the light on the shower goes off, the light on my...

The drain cover in my shower cubicle is flaking and discoloured. I was hoping to remove the centre section and replace it with one of those slightly-domed covers, concealing the outer ring. Unfortunately it seems they all come with a 42mm spigot attached, and the hole is just 40mm. I don’t...

I have a dripping shower valve. I have take away the face plate and at a complete loss at what to do. There's currently a bag sitting over it which isnt pleasing the family. Any guidance appreciated.